How to Apply Decals
HOW TO APPLY ADHESIVE VINYL DECAL
Pls complete all 5 steps below:
STEP 1. Decide on placement location and thoroughly clean the area with alcohol wipes.
STEP 2. Prepare the decal for application by gently rubbing a squeegee or credit card across the clear transfer tape to remove air bubbles.
STEP 3. Peel paper backing of decal, exposing the sticky side. If the decal clings to the paper backing, slowly replace the paper backing and repeat STEP 2.
STEP 4. Place decal on desired location then rub firmly in place from the center out. Use a squeegee or credit card to smooth it out.
STEP 5. Carefully peel the clear transfer tape off at an angle. If the decal starts pulling away from surface, repeat STEP 4.
____________________________________________________________________
HOW TO APPLY IRON ON TRANSFER TO CONVERSE SHOES (HEAT TRANSFER VINYL)
___________________________________________________________________________
HOW TO APPLY IRON ON TRANSFER (HEAT TRANSFER VINYL)
HOW TO APPLY YOUR IRON ON TRANSFER USING A HOME IRON
1. Pre-heat your iron to the highest setting (linen or cotton) WITHOUT steam.
2 2. Iron your garment, specifically the area where you’ll place your design, to remove any wrinkles or moisture.
3. 3. Remove the paper/frosted backing from your vinyl transfer
4. 4. Place the clear transfer sheet with design on your garment.
5. 5. Cover transfer with the paper/frosted backing or a thin sheet e.g. parchment paper or pillow case.
6. 6. On a flat hard surface, place your iron on top of the transfer and apply firm, even pressure for 20 – 30 seconds. Do not slide your iron around.
7. 7. Pick up and move your iron to another spot on the design and repeat the previous step.
8. 8. Slowly peel away the clear transfer sheet from design. If design begins to come off with transfer paper, repeat step 6.
